Carbon plaster white 25kg dragged 2mm Carbon Fassadenputz R20 CAPAROL

Carbon Fassadenputz is a new generation high-tech facade plaster, developed for maximum resistance, durability and visual effect. Reinforced with carbon fibers and enriched with photocatalytic properties, it provides a self-cleaning effect, active protection against microorganisms and remarkable weather resistance. The plaster combines exceptional strength and vapor permeability with an elegant decorative finish.

Created for modern energy-efficient facades, Carbon Fassadenputz is the perfect solution for finishing thermal insulation systems, new construction or renovations. Easy to apply and available in a rich color palette, it guarantees not only durability over time, but also a facade that breathes, shines and is maintained almost effortlessly.

Application

Carbon Fassadenputz is a decorative structural plaster designed for outdoor use, with a strong self-cleaning effect and excellent resistance to weathering. It is used as a finishing layer in the following cases:

• Thermal insulation systems, especially from the Carbon series
• Unplastered concrete
• Mortar plasters of groups PII and PIII (DIN V 18550)
• Existing surfaces painted with load-bearing, matt dispersion paints

Substrate preparation

• The substrate must be sound, dry, clean, free of grease, dust and separating agents.
• Load-bearing old coatings are cleaned mechanically or with a high-pressure water jet.
• Non-load-bearing coatings (old paints, varnishes, plasters) are completely removed.
• Mold and mildew are treated with Capatox and the surface is allowed to dry completely.
• Mineral plasters are primed with Caparol Putzgrund after the required drying time (usually 2 weeks).
• Highly absorbent and sandy surfaces are treated with OptiGrund ELF or Dupagrund depending on the condition.
• Concrete surfaces - if necessary, they are cleaned mechanically, then primed according to their absorption.
• Surfaces with dispersion or silicate paints are treated according to the type of coating.

Method of work

• Mixing: The plaster is stirred well before use with a slow-speed mixer (up to 400 rpm) until a homogeneous mixture is obtained.
• Priming: Before application, it is mandatory to use a colored primer Caparol Putzgrund, colored in a shade close to the final color.
• The plaster is applied evenly to the thickness of the granulate with a stainless steel trowel.
• It is structured with a plastic or PU spatula: "R" structure - granular
• When spraying, choose a suitable nozzle and a pressure of 0.3-0.4 MPa.
• Work "wet on wet", without interruption, to avoid visible transitions.
• Use the same tools and techniques for structuring the same surface.
• At lower temperatures and high humidity - extend the drying time.
• Working conditions: Temperature: +5°C to +30°C
• Do not work in direct sunlight, strong wind, fog or high humidity

Characteristics

• Plaster type: Organic, with R ("grainy") structure
• Reinforcement: Carbon fibers for increased strength
• Water vapor permeability: Class V1 (very good vapor permeability)
• Water absorption: Class W3 (low water absorption)
• Granulation and consumption: R20 (pulled, granulation 12.0 mm): 2.5-2.8 kg/sq.m
• Gloss level: Matt
• UV resistance: High, retains color for a long time
• Protective film: Against mold, fungi and mildew (photocatalytic action)
• Weather resistance: High, suitable for outdoor conditions
• Application method: Manual with a trowel or by spraying
• Working temperature: +5°C to +30°C during application and drying
• Packaging: 25 kg
• Color: White, with the possibility of coloring up to 2% colorant